ISO 5610:2012 pdf download.Tool holders with rectangular shank  for ind exable inserts -Part 12:Style S.
This part of ISO 5610 specifies tool holders with rectangular shank, style S, i.e. with offset shank and cutting edge angle Kr = 45° for side cutting.
These tool holders are primarily intended for indexable inserts made of hard metal or other cutting materials to be mounted by clamping and to be used for turning operations.
NOTE The symbols for the dimensions shown in the tables of this part of ISO 5610 and the corresponding preferred symbols of properties defined in ISO/TS 13399-2 and ISO/TS 13399-3 are given in ISO 5610-1:2014, Table A.1.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 5608:20 12, Turning and copying tool holders and cartridges for indexable inserts — Designation
ISO 5610-1:2014, Tool holders with rectangular shank for indexable inserts — Part 1: General survey, correlation and determination of dimensions
3 Dimensions
3.1 General
It is not necessary for tool holders to comply with the pictorial representation; only the dimensions given shall be observed.
For determination of dimensions h1,f, and l1, see ISO 5610-1.
For explanation of the designation code for tool holders, see ISO 5608.
NOTE The values of rake angles and inclination angles shown in the figures are recommended values; they can vary according to the application.
4 Designation
A tool holder in accordance with this part of Iso 5610 shall be designated by:
“Tool holder”;
b) a reference to this part of ISO 5610 (i.e. ISO 5610-1 2);
c) type of mounting, in accordance with ISO 5608;
d) symbol for indexable insert shape, in accordance with ISO 5608;
e) symbol for tool style, in accordance with ISO 5608;
f) symbol for the indexable insert normal clearance, in accordance with ISO 5608;
g) symbol for hand of tool, in accordance with ISO 5608;
h) its height, h1, width, b, and length, l (symbol for tool length in accordance with ISO 5608);
i) its cutting edge length, 13.
EXAMPLE 1 Tool holder for a screw-clamped (S) rhombic indexable insert shape C (C), tool holder style S (S), for normal clearance of indexable insert a = 70 (C), right-hand type (R), with height h1 = 10 mm and width b = 10 mm (1010), length 1 = 70 mm (E), for cutting edge length 13 = 6,4 mm (06) is designated as follows:
Tool holder ISO 5610-12 – SCSCR 1010 E06
EXAMPLE 2 Tool holder for a horizontally mounted, bore-clamped (P) square indexable insert shape S (S), tool holder style S (S), for normal clearance of indexable insert a = 00 (N), right-hand type (R), with height hi = 32 mm and width b = 25 mm (3225), length l = 170 mm (P), for cutting edge length 13 = 12,7 mm (12) is designated as follows:
Tool holder ISO 5610-12 – PSSNR 3225 P12
EXAMPLE 3 Tool holder for countersunk screw-clamped (S) round indexable insert shape R (R), tool holder style S (S), for normal clearance of indexable insert a = 70 (C), right-hand type (R), with height h1 = 20 mm and width b = 20 mm (2020), length = 125 mm (K), diameter d = 10 mm (10) is designated as follows.ISO 5610 pdf download.